Ds-mode – Avaya X330WAN User Manual
Page 117
General: Device Commands
Avaya X330WAN User’s Guide
95
Note:
If
N/A
is displayed for the EW_Archive file, the Device Manager software is
not loaded correctly. Download the Device Manager software again.
ds-mode
Use the
ds-mode
command to set the controller’s mode.
Note:
After setting the controller’s mode, this command:
1. Erases startup-config.
2. Resets the device.
Syntax
ds-mode
[e1
|
t1]
Parameters
Example
X330WAN-2DS1-1(configure)# ds-mode e1
Your startup-config file will be erased!
Your telnet session will be disconnected.
This operation may take a few minutes
The WAN module will reset, in order to make the required change.
Do you want to continue (Y/N)?
Note:
If this command is entered when the correct mode is selected (for example,
entering
ds1-mode e1
when the device is already in E1 mode), no errors are
generated.
Caution:
This action takes approximately 20 seconds. Do not enter any commands
after confirming restart until after the restart process is complete.
e1
Sets the device to E1 mode. All controllers are set to operate as E1.
t1
Sets the device to T1 mode. All controllers are set to operate as T1. This is
the default.