Avaya X330WAN - Manual (Page 201)

Layer 3 CLI Commands
Avaya X330WAN User’s Guide 179
ip ospf authentication-key (Interface context)
Use the ip ospf authentication-key command to configure the interface
authentication password. The no form of this command removes the OSPF
password.
Note: This command is executed from the Serial, Loopback, Fast Ethernet, and
FabricFastEthernet interfaces.
Syntax
[no] ip ospf authentication-key <key>
Parameters
Example
config-if:ip ospf authentication-key my_pass
ip ospf cost (Interface context)
Use the ip ospf cost command to configure interface metric. The no form of
this command sets the cost to its default. The default is 1.
Note: This command is executed from the Serial, Loopback, Fast Ethernet, and
FabricFastEthernet interfaces.
Syntax
[no] ip ospf cost <cost>
Parameters
Example
ip ospf cost 10
key A string (up to 8 characters).
cost An integer from 1 to 65535.