Avaya X330WAN - Manual (Page 230)

Chapter 6 X330WAN CLI Commands
208 Avaya X330WAN User’s Guide
192.168.66.24
Primary IP Address: 192.168.66.23
Primary IP Address was chosen by default
Preemption Mode: enabled
# of times Master: 1
# of received Advertisements: 0
# of transmitted Advertisements: 13
# of received Advertisements with Security Violations: 0
timers basic (Router-RIP context)
Use the timers basic command to set RIP timers. The no form of this command
sets the RIP timers to their default values.
Syntax
[no] timers basic <update> <invalid>
Parameters
Example
X330WAN-2DS1-1(configure router:rip)# timers basic 30 180
timers spf (Router-OSPF context)
Use the timers spf command to configure the delay between runs of OSPF’s
SPF calculation. The no form of this command restores the default value, 3 seconds.
Syntax
[no] timers spf <spf-holdtime>
Parameters
Example
X330WAN-2DS1-1(super)# timers spf 5
update RIP update timer, in seconds (minimum 30).
invalid RIP invalid route timer, in seconds (minimum 30).
spf-holdtime The time in seconds of the delay between runs of OSPF’s SPF
calculation. The range of acceptable values is 1 to 3600.