Avaya X330WAN - Manual (Page 66)

Chapter 4 Operational Concepts and Configuration Examples
44 Avaya X330WAN User’s Guide
The following is the configuration procedure for the X330WAN, as shown in Figure
4.6:
X330WAN-2DS1-1(super)# interface Loopback 1
Done!
X330WAN-2DS1-1(super-if:Loopback1)# ip address 10.10.10.10 32
The Primary management interface has changed. Please copy the running
configuration to the start-up configuration file, and reset the WAN
router.
Done!
X330WAN-2DS1-1(super-if:Loopback1)# exit
X330WAN-2DS1-1(super)# copy running-config startup-config
X330WAN-2DS1-1(super)# reset
X330WAN-2DS1-1(super)# controller e1 1
Done!
X330WAN-2DS1-1(super-controller:1)# channel-group 1 timeslots 1-5
Done!
X330WAN-2DS1-1(super-controller:1)# exit
X330WAN-2DS1-1(super)# interface Serial 1:1
Done!
X330WAN-2DS1-1(super-if:Serial1:1)# ip address 10.23.4.5 24
Done!
X330WAN-2DS1-1(super-if:Serial1:1)# exit
X330WAN-2DS1-1(super)# interface FastEthernet 1
Done!
X330WAN-2DS1-1(super-if:FastEthernet1)# ip address 10.64.15.1 24
Done!
X330WAN-2DS1-1(super-if:FastEthernet1)# exit
X330WAN-2DS1-1(super)# interface FabricFastEthernet 1
Done!
X330WAN-2DS1-1(super-if:FabricFastEthernet1)# shutdown
Interface FabricFastEthernet 1, changed state to administratively
down
Done!
X330WAN-2DS1-1(super-if:FabricFastEthernet1)# exit
X330WAN-2DS1-1(super)# ip route 192.198.10.0 24 10.64.15.2
Done!
Backup Interfaces
A Backup interface is activated when the Primary interface fails and is deactivated
when the Primary interface is restored. You can configure Backup relations between
a pair of any Layer 2 Serial interfaces. A PPP session, Frame Relay interface, and
Frame Relay Sub-interface can serve as a Backup interface to any other Serial
interface on a module level, including interfaces on different Serial ports.