Avaya X330WAN - Manual (Page 155)

Interface Serial CLI Commands
Avaya X330WAN User’s Guide 133
Example
To enter interface serial mode port 1, channel group 3 in ip-interface 1:
X330W-2DS1(configure)# interface Serial 1:3
IP interface for PPP encapsulation:
interface Serial 1:3.1
Sub interface for frame-relay encapsulation:
interface Serial 1:3.1 point-to-point
IP interface for frame-relay encapsulation:
interface Serial 1:3.1.1
interface Serial (X330WAN-2USP)
Use the interface Serial command to create and/or enter interface Serial
context. For LAN interfaces, use this command to create the interface. The no form
of this command deletes an IP interface.
Syntax
[no] interface Serial <if-number>[<if-link-type>]
Parameters
Example
To enter interface serial mode port 1:
X330W-2USP(super)# interface Serial 1
IP interface for PPP encapsulation:
interface Serial 1.1
Sub interface for frame-relay encapsulation:
interface Serial 1.1 point-to-point
IP interface for frame-relay encapsulation:
interface Serial 1.1.1
if-number Comprised of: port[.ip-interface|sub-interface[.ip-
interface]] .
port The controller number (port number) for this serial port. For
the X330W-2DS1, this value is either 1 or 2.
sub-interface The Sub-interface number. An integer from 0 to 1024.
ip-interface The IP interface number within this interface (as a number of
IP interfaces might be bound to a Layer 3 interface). An integer
from 0 to 1024.
if-link-type Point-to-point.