Avaya X330WAN - Manual (Page 175)

Loopback CLI Commands
Avaya X330WAN User’s Guide 153
Loopback CLI Commands
This section contains a list of all Loopback related CLI commands.
interface Loopback
Use the interface Loopback command to create and/or enter interface
Loopback context. The no form of this command deletes a Loopback interface or an
IP interface.
Syntax
[no] interface Loopback [<interface number>[.ip-interface]]
Parameters
Example
X330WAN-2DS1-1(configure)# interface Loopback 1
X330WAN-2DS1-1(configure)# interface Loopback 1.0
X330WAN-2DS1-1(configure)# no interface Loopback 1.0
General Layer 2 Interface CLI Commands
This section contains a list of all general Layer 2 related CLI commands.
bandwidth (X330WAN-2USP Interface context)
Use the bandwidth command to set the bandwidth informational parameter for the
interface. The no form of this command sets the bandwidth informational parameter
to the default value.
Note: This command is executed from the Serial, Loopback, Fast Ethernet, and
FabricFastEthernet interfaces.
Syntax
[no] bandwidth [<kilobits>]
interface number An integer from 0 to 99.
ip-interface The IP interface number within this interface (a number of
IP interfaces may be bound to a Layer 3 interface). An
integer from 0 to 1024.