Avaya X330WAN - Manual (Page 41)

Configuring the X330WAN
Avaya X330WAN User’s Guide 19
6 Connect the Console port to the modem’s DB-25 port using the DB-25 to RJ-45
connector. The X330WAN enters Modem mode.
7 Dial into the module from a remote station, and open a Telnet session to the PPP
interface IP address configured in step 3.
Checking the Modem Configuration
After establishing a modem connection, use the show interface console
command to display information regarding your modem interface. Verify that the
output information is correct.
Establishing a Telnet Connection
Perform the following steps to establish a Telnet connection to the X330WAN for
configuration of WAN parameters. Telnet directly to one of the IP interfaces of the
X330WAN:
1
Connect your station to the network.
2 Verify that you can communicate with the X330WAN using the
ping <host> [<interval> [<size>]] command to the IP of the X330WAN. If
there is no response, check the IP address and default gateway of both the
X330WAN and the station using the
show ip route command.
3 From the Microsoft Windows taskbar of your PC, click Start and then Run (or
from the DOS prompt of your PC), then start the Telnet session by typing:
telnet <IP address of X330WAN>
For example: telnet 149.49.32.134
Note: You can also Telnet the IP address of the P330 stack. If you Telnet the IP
address of the stack, a connection is established with the Switch CLI entity of the
Master module of the stack.
If you want to connect to the X330WAN CLI entity, use the
session wan <module
number in stack> command.
4 When prompted for a Login Name, enter the default name root .
5 When prompted for a password, enter root . You can now configure the
X330WAN.