Avaya X330WAN - Manual (Page 177)

General Layer 2 Interface CLI Commands
Avaya X330WAN User’s Guide 155
Parameters
Note: This command has different outputs for PPP and Frame Relay, and for
X330W-2DS1 and X330W-2USP. Two output examples are provided.
Output Example for X330W-2DS1 with PPP on both controllers:
X330WAN-2DS1-1(super)# show interfaces
FabricFastEthernet 1 is up, line protocol is up
MTU 1500 bytes, Bandwidth 100000 Kbit
Reliability 255/255 txLoad 1/255 rxLoad 1/255
Encapsulation ARPA
Link status trap disabled
Full-duplex, 100Mb/s
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, Last output 00:00:08
Last clearing of 'show interface' counters 00:06:24
5 minute input rate 81966 bits/sec, 155 packets/sec
5 minute output rate 8 bits/sec, 0 packets/sec
0 input drops, 0 output drops, 0 unknown protocols
115 packets input, 7360 bytes
115 broadcasts received, 0 giants
0 input errors, 0 CRC
4 packets output, 256 bytes
0 output errors, 0 collisions
FabricFastEthernet 1:1 is up, line protocol is up
Physical address is 00.40.0d.bf.20.01,
Internet address is 4.0.0.1, mask is 255.0.0.0
type The type of this interface. Select one of the following:
FastEthernet, Serial, FabricFastEthernet, Loopback, or
Console .
identifier • For a FastEthernet interface — An integer (1).
• For a Serial interface —
<port>:<channel-group> (for PPP)
or <port> (for Frame Relay).
<port> — Either 1 or 2.
<channel-group> — For E1, an integer, 0-30.
For T1, an integer, 0-23.
• For a FabricFastEthernet interface — 1[:<vlan>]
<vlan> - An integer, 1-3071.
• For a Loopback interface — An integer, 1-99.