Avaya X330WAN - Manual (Page 48)

Chapter 3 Initial Configuration
26 Avaya X330WAN User’s Guide
Note: If you need to define more than one IP address on the interface, enter a new
interface serial n.m context, where n is the port number and m is the additional
IP interface. (For example: typing interface serial 1.1 enables you to configure an IP
interface on interface Serial 1, in addition to the IP interface created in step 4.)
6 Repeat step 1 through step 5 to configure the second USP interface if needed.
7 Use the frame-relay lmi commands to change the Local Management
Interface (LMI) parameters from their default values if required, or use the
frame-relay traffic-shaping command to activate Traffic Shaping on the
Frame Relay interface. For more information on Traffic Shaping, refer to "Traffic
Shaping and Marking" on page 47.
8 Type exit to return to Supervisor mode.
9 Use the interface serial <if-number>[<if-link-type>] command to
enter the Frame Relay Sub-interface context. (For example, typing interface
serial 2.1 point-to-point creates a Point-to-Point type Sub-interface 1 on
port 2.)
Note: Currently only Point-to-Point Sub-interface types are supported.
10 Configure a Data Link Connection Identifier (DLCI) for the Sub-interface using
the frame-relay interface-dlci <DLCI number> command.
11 If required, configure a Priority DLCI Group using the frame-relay
priority-dlci-group <DLCI1>[<DLCI2>[<DLCI3>[<DLCI4>]]] command.
For more information, refer to "Priority DLCI" on page 46.
12 Configure an IP address for the Sub-interface using the ip address <ip
address> <mask> [<admin state>] command.
13 Type exit to return to Supervisor mode.
14 Repeat step 9 through step 12 to configure additional Frame Relay
Sub-interfaces on the same Frame Relay interface.
Table 3.1 provides the different configuration contexts for the X330W-2USP CLI.
This table uses the following legend:
•
x = physical port number
• y = channel group
• z = sub frame relay interface index
• w = IP interface index