Avaya X330WAN - Manual (Page 192)

Chapter 6 X330WAN CLI Commands
170 Avaya X330WAN User’s Guide
ip address
Use the ip address command to assign an IP address and mask to an interface.
The
no form of the command deletes an IP interface.
Syntax
[no] ip address <ip-address> <mask> [<admin-state>]
Parameters
Example
To assign the IP address 192.168.22.33 with mask 255.255.255.0 to the Fast Ethernet
interface:
X330WAN-2DS1-1(super-if:FastEthernet1)# ip address 192.168.22.33 24
ip admin-state (Interface context)
Use the ip admin-state command to set the administrative state of an IP
interface. The default state is up.
Syntax
ip admin-state <up/down>
Parameters
ip bootp-dhcp network (Interface context)
Use the ip bootp-dhcp network command to select the network from which
the BOOTP/DHCP server should allocate an address. This command is required
only when there are multiple IP interfaces over the FabricFastEthernet. The no
form of this command restores the default.
Note: This command is executed from the Fast Ethernet and FabricFastEthernet
interfaces.
ip address The IP address assigned to the interface.
mask Mask for the associated IP subnet.
admin-state The administration status, i.e., either up or down (default is up).
This parameter is not applicable for the Console interface of the
X330WAN.
up/down Administrative state of the interface. The choices are Up (active) or
Down (inactive).