Avaya X330WAN - Manual (Page 88)

Chapter 4 Operational Concepts and Configuration Examples
66 Avaya X330WAN User’s Guide
X330WAN-2USP-1(super-subif:Serial1.1)# frame-relay class-dlci 16
voip
(6)
X330WAN-2USP-1(super-subif:Serial1.1)# exit
X330WAN-2USP-1(super)# ip default-gateway serial 1.1
* Description of footnoted commands (also applies to identical stages in configuring
Site B):
(1) The CIR Out value depends on the number of phones (approx. 26Kbps per
phone for G.729 CODEC).
(2) This is a value that causes the EIR to reach the Access Rate (192Kbps), where
EIR=(Bc+Be)/Tc, in this configuration EIR = (16000+8000)/0.125 =192Kbps.
(3) This value is usually 1/8 of the CIR value, in this configuration Tc = 125msec.
(4) In this configuration the non-high priority data packets are marked as DE when
the transfer rate
reaches 80% of the CIR.
(5) At this stage, you configure X330WAN to fragment the data packets to prevent
the long packets from causing delay to the voice packets.
(6) At this stage you assign map-class VoIP to the interface DLCI.
Configuration Example 1 for Site B - Single VC Between Sites
Following is the configuration procedure for the X330WAN-2USP, as shown in
Figure 4.11:
•
Loopback and PMI interfaces configuration:
X330WAN-2USP-1(super)# interface Loopback 1
X330WAN-2USP-1(super-if:Loopback1)# ip address 20.20.20.20 24
The Primary management interface has changed. Please copy the running
configuration to the start-up configuration file, and reset the
device.
X330WAN-2USP-1(super-if:Loopback1)# exit
X330WAN-2USP-1(super)# copy running-config startup-config
X330WAN-2USP-1(super)# reset
• FabricFastEthernet interface configuration:
X330WAN-2USP-1(super)# interface FabricFastEthernet 1:1
X330WAN-2USP-1(super-if:FabricFastEthernet1:1)# ip address 3.3.3.1
24
X330WAN-2USP-1(super-if:FabricFastEthernet1:1)# exit
X330WAN-2USP-1(super)# interface FabricFastEthernet 1:1.1
X330WAN-2USP-1(super-subif:FabricFastEthernet1:1.1)# ip address
4.4.4.1 24
X330WAN-2USP-1(super-if:FabricFastEthernet1:1.1)# exit
X330WAN-2USP-1(super)# interface FabricFastEthernet 1:2
X330WAN-2USP-1(super-if:FabricFastEthernet1:2)# ip address
33.33.33.1 24