Avaya X330WAN - Manual (Page 64)

Chapter 4 Operational Concepts and Configuration Examples
42 Avaya X330WAN User’s Guide
Configuration Example for Branch Office 2
The following is the configuration procedure for the X330WAN in Branch Office 2,
as shown in Figure 4.5:
X330WAN-2USP-1(super)# interface Loopback 1
Done!
X330WAN-2USP-1(super-if:Loopback1)# ip address 20.20.20.20 32
The Primary management interface has changed. Please copy the running
configuration to the start-up configuration file, and reset the WAN
router.
Done!
X330WAN-2USP-1(super-if:Loopback0)# exit
X330WAN-2USP-1(super)# copy running-config startup-config
X330WAN-2USP-1(super)# reset
X330WAN-2USP-1(super)# interface FabricFastEthernet 1:1
Done!
X330WAN-2USP-1(super-if:FabricFastEthernet1:1)# ip address
10.34.45.1 24
Done!
X330WAN-2USP-1(super-if:FabricFastEthernet1:1)# exit
X330WAN-2USP-1(super)# interface FabricFastEthernet 1:2
Done!
X330WAN-2USP-1(super-if:FabricFastEthernet1:2)# ip address
10.23.10.1 16
Done!
X330WAN-2USP-1(super-if:FabricFastEthernet1:2)# exit
X330WAN-2USP-1(super)# interface Serial 1
Done!
X330WAN-2USP-1(super-if:Serial1)# encapsulation frame-relay
X330WAN-2USP-1(super-if:Serial1)# exit
X330WAN-2USP-1(super)# interface Serial 1.1 point-to-point
Done!
X330WAN-2USP-1(super-subif:Serial1.1)# frame-relay interface-dlci 22
Interface Serial 1.1 - DLCI 22 state changed to DELETED
Done!
X330WAN-2USP-1(super-if:Serial1)# ip address 10.170.17.1 24
Done!
X330WAN-2USP-1(super)# ip route 192.168.0.0 16 serial 1:1
Done!