Avaya X330WAN - Manual (Page 168)

Chapter 6 X330WAN CLI Commands
146 Avaya X330WAN User’s Guide
Parameters
Example
X330W-2USP-1(super-if:Serial2.1)# frame-relay priority-dlci-group 16
17 18 19
Note: If you specify less than four DLCIs, the last DLCI specified is automatically
used for the missing priorities.
frame-relay traffic-shaping (Serial interface context)
Use the frame-relay traffic-shaping command to enable traffic shaping. The
no form of this command disables traffic shaping.
Syntax
[no] frame-relay traffic-shaping
Example
X330W-2USP-1(super-if:Serial2)# frame-relay traffic-shaping
keepalive (Serial interface context Frame Relay encapsulation)
Use the keepalive command to enable sending the LMI t391dte status requests.
The no form of this command disables LMI.
Syntax
[no] keepalive [<Seconds>]
Parameters
DLCI1 The DLCI assigned to high priority traffic, an integer from 16 to 1007.
DLCI2 The DLCI assigned to medium priority traffic, an integer from 16 to 1007.
DLCI3 The DLCI assigned to normal priority traffic, an integer from 16 to 1007.
DLCI4 The DLCI assigned to low priority traffic, an integer from 16 to 1007.
Seconds The number of seconds between status requests (an integer from 5 to
30). Entering
keepalive without a parameter returns the keepalive to
its default of 10 seconds. Entering keepalive 0 or no keepalive
disables LMI.