Avaya X330WAN User Manual
Page 185
General Layer 2 Interface CLI Commands
Avaya X330WAN User’s Guide
163
Note:
In rare cases, the sub-frame relay traffic information presented by this
command can include packets that are eventually dropped before transmission.
snmp trap link-status (Serial and Fast Ethernet interface contexts)
Use the
snmp trap link-status
command to enable Link Up and Link Down
traps. The
no
form of this command deactivates the traps for the interface. By
default the link-status trap generation is disabled.
Syntax
[no] snmp trap link-status
Example
snmp trap link-status
100Mb/s, 10Mb/s The Fast Ethernet speed.
Backup interface
Indicates if this interface is used as a backup interface for
another.
Failure delay
The time in seconds between the Primary interface going down
and the Backup interface activation.
Secondary disable
delay
The time in seconds between the Primary interface restoration
and the Backup interface deactivation.
LMI enq sent
The number of t391 status requests sent (Frame Relay interfaces
only).
LMI stst recvd
The number of status messages received from the DCE (Frame
Relay interfaces only).
LMI upd recvd
The number of LMI updates received from the DCE (Frame
Relay interfaces only).
DTE LMI
down/up
The status of the LMI. After the first message is received from
the DCE, the status is up (Frame Relay interfaces only).
LMI DLCI
The DLCI used for the LMI messages (Frame Relay interfaces
only).
LMI type
The LMI type (Frame Relay interfaces only).
Frame relay
DTE/DCE
The module type (Frame Relay interfaces only).
Field
Description