Avaya X330WAN User Manual
Page 86
Chapter 4
Operational Concepts and Configuration Examples
64
Avaya X330WAN User’s Guide
•
The IP phones are configured with the following DSCP tagging:
— Voice = DSCP 46
— Voice control = DSCP 34
•
Network IPs (all 24 mask):
— IP phones - 1.1.1.0 (VLAN 1)
— Data - 11.11.11.0 (VLAN 2)
— Serial - 2.2.2.1
— Gatekeeper - 149.49.54.81
— MGP - 149.49.54.82
— VoIP (MGP) - 149.49.54.83
Site B contains four IP phones and a data LAN connected to a P333T-PWR switch in
a stack with a G700 Media Gateway. The G700 Media Gateway houses an
X330W-2USP expansion module that is connected to a Frame Relay network via a
192Kbps Frame Relay encapsulated V.35 interface.
Following are the connection details for Site B:
•
A single VC with:
— CIR = 128Kbps
— DLCI = 16
•
The IP phones are configured with DSCP tagging:
— Voice = DSCP 46
— Voice control = DSCP 34
•
Network IPs (all 24 mask):
— IP phones - 3.3.3.0 (VLAN 1)
— Data - 33.33.33.0 (VLAN 2)
— Serial - 2.2.2.2
— MGP - 4.4.4.10
— VoIP (MGP) - 4.4.4.11
Configuration Example 1 for Site A - Single VC Between Sites
Following is the configuration procedure for the X330WAN-2USP, as shown in
Figure 4.11. Commands with footnotes are described at the end of the configuration
procedure.
•
Loopback and PMI interfaces configuration:
X330WAN-2USP-1(super)# interface Loopback 1
X330WAN-2USP-1(super-if:Loopback1)# ip address 10.10.10.10 24
The Primary management interface has changed. Please copy the running
configuration to the start-up configuration file, and reset the
device.
X330WAN-2USP-1(super-if:Loopback1)# exit
X330WAN-2USP-1(super)# copy running-config startup-config
X330WAN-2USP-1(super)# reset