Configuring the fabricfast ethernet interface – Avaya X330WAN User Manual
Page 43
Configuring the X330WAN
Avaya X330WAN User’s Guide
21
PMI is configured, the following message appears:
The primary management interface has changed.
For this change to take effect, you need to copy running-config
startup-config and then reset the device.
Enter the
copy running-config startup-config
and
reset
commands at this
stage.
Configuring the FabricFast Ethernet Interface
All CLI commands mentioned in this section are described in Chapter 6: X330WAN
CLI Commands.
To configure a FabricFast Ethernet interface:
1
Use the
interface FabricFastEthernet
<if-number>
command to enter the
FabricFast Ethernet interface context, where the if-number format is
port[:vlan[.ip-interface index]]
.
Note:
You do not need to include the ip-interface index if you configure only one IP
interface.
2
Use the
ip address
command to assign an IP address to the interface.
For example:
To configure the IP addresses 10.10.10.1 on VLAN 2 and 20.20.20.1
and 30.30.30.1 on VLAN 3 perform the following:
X330WAN-2USP-1(super)# interface FabricFastEthernet 1:2
X330WAN-2USP-1(super-if:FabricFastEthernet1:2)# ip address
10.10.10.1 24
X330WAN-2USP-1(super-if:FabricFastEthernet1:2)# exit
X330WAN-2USP-1(super)# interface FabricFastEthernet 1:3.1
X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.1)# ip address
20.20.20.1 24
X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.1)# exit
X330WAN-2USP-1(super)# interface FabricFastEthernet 1:3.2
X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.2)# ip address
30.30.30.1 24
X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.2)# exit
Note:
The first IP interface created in the X330WAN automatically becomes the
PMI, described in detail on page 34. It is recommended to configure the Loopback
interface as the first Layer 2 interface and to configure an IP interface on it. After the
PMI is configured, the following message appears: