Avaya X330WAN - Manual (Page 138)

Chapter 6 X330WAN CLI Commands
116 Avaya X330WAN User’s Guide
Note: If you can not configure the hardware’s receive sensitivity, the receive
sensitivity is fixed at 36 dB and is unaffected if you enter gain26 or gain36 .
Example
X330WAN-2DS1-1(config-controller:1)# no cablelength
The following example changes the CLI receive sensitivity to match the actual
receive sensitivity of the hardware and adds 15 dB of attenuation to the transmit
signal:
X330WAN-2DS1-1(config-controller:1)# cablelength long gain36 -15db
cablelength short (Controller context)
Use the cablelength short command to configure transmit attenuation for a
cable length (line build-out) of 655 feet or shorter for a T1 trunk with a DSX-1
interface. This command configures the attenuation using the loop length. The
no
form of this command restores the default value.
Note: This command can only be performed if the controller is set to T1.
Syntax
cablelength short {133ft|266ft|399ft|533ft|655ft}
Parameters
-7.5db Sets the transmit attenuation to 7.5 dB.
0db Sets the transmit attenuation to 0 dB. This is the default value.
133 Cable length of 0 to 133 feet. This is the default value.
266 Cable length of 134 to 266 feet.
399 Cable length of 267 to 399 feet.
533 Cable length of 400 to 533 feet.
655 Cable length of 534 to 655 feet.