Avaya X330WAN - Manual (Page 96)

Chapter 4 Operational Concepts and Configuration Examples
74 Avaya X330WAN User’s Guide
• Network IPs:
— IP phones - 10.200.231.0 24 (VLAN 1)
— Serial - 192.168.2.6 30
— DHCP Server - 10.200.231.251
Site B contains IP phones connected to a P333T-PWR switch. The P333T-PWR
switch houses a X330W-2DS1 expansion module that is connected to the WAN via a
24 timeslot (1.536 Mbps) T1 interface. A DEFINITY Gateway is connected to the
P333T-PWR via the LAN. Following are the connection details for Site B:
•
IP phone are configured with DSCP tagging:
— Voice = DSCP 46
— Voice control = DSCP 34
• The CLAN in the DEFINITY has a default RTP UDP port range is 2048 to 3028.
• Network IPs:
— IP phones - 149.49.47.0 24 (VLAN 1)
— Serial - 192.168.2.5 30
— CLAN - 149.49.47.3
— Prowler - 149.49.47.4
Configuration Example for Site A
The following is the configuration procedure for the X330WAN-2DS1, as shown in
Figure 4.12. Commands with footnotes are described at the end of the configuration
procedure.
•
Loopback and PMI interfaces configuration:
X330WAN-2DS1-1(super)# interface Loopback 1
X330WAN-2DS1-1(super-if:Loopback1)# ip address 10.10.10.10 24
The Primary management interface has changed. Please copy the running
configuration to the start-up configuration file, and reset the
device.
X330WAN-2DS1-1(super-if:Loopback1)# exit
X330WAN-2DS1-1(super)# copy running-config startup-config
X330WAN-2DS1-1(super)# reset
• FabricFastEthernet interface configuration:
X330WAN-2DS1-1(super)# interface FabricFastEthernet 1:1
X330WAN-2DS1-1(super-subif:FabricFastEthernet1:1.1)# ip address
10.200.231.250 24
X330WAN-2DS1-1(super-if:FabricFastEthernet1:1.1)# exit
• Configuration of a Policy list with the appropriate DSCP-CoS mappings:
X330WAN-2DS1-1(super)# set qos policy-source local
X330WAN-2DS1-1(super)# ip access-list-name 100 voice
X330WAN-2DS1-1(super)# ip access-list-dscp operation 100 34 fwd7
(1)
X330WAN-2DS1-1(super)# ip access-list-dscp operation 100 46 fwd6
(2)