Avaya X330WAN - Manual (Page 181)

General Layer 2 Interface CLI Commands
Avaya X330WAN User’s Guide 159
LMI DLCI 0, LMI type is ANSI Annex D, frame relay DTE
Last input never, Last output never
Last clearing of 'show interface' counters 00:59:21
VoIP mode disabled.
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 input drops, 0 output drops, 0 unknown protocols
0 packets input, 0 bytes
0 broadcasts received, 0 giants
0 input errors, 0 CRC, 0 abort
0 packets output, 0 bytes
0 output errors, 0 collisions ,0 carrier transitions
DCD = down DSR = down DTR = up RTS = up CTS = down
Serial 2 is up (partially), line protocol is up
MTU 1500 bytes, Bandwidth 2048 Kbit
Reliability 255/255 txLoad 1/255 rxLoad 1/255
Encapsulation FRAME-RELAY IETF, loopback not set
Link status trap disabled
LMI enq sent 374, LMI stat recvd 373, LMI upd recvd 0, DTE LMI up
LMI DLCI 0, LMI type is ANSI Annex D (Auto Detected), frame relay DTE
Last input 00:00:01, Last output 00:00:01
Last clearing of 'show interface' counters 00:59:21
VoIP mode disabled.
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 19 bits/sec, 0 packets/sec
0 input drops, 0 output drops, 0 unknown protocols
356 packets input, 5284 bytes
0 broadcasts received, 0 giants
0 input errors, 0 CRC, 0 abort
378 packets output, 5688 bytes
0 output errors, 0 collisions, 0 carrier transitions
DCD = up DSR = up DTR = up RTS = up CTS = up
Serial 2.1 is up, line protocol is up
Internet address is 5.0.0.1, mask is 255.0.0.0
Primary management interface
MTU 1500 bytes, Bandwidth 2048 Kbit
Encapsulation FRAME-RELAY IETF, loopback set
Link status trap disabled
Last input never, Last output 00:00:38
Last clearing of 'show interface' counters 00:59:21
0 input drops, 0 output drops, 0 unknown protocols