Avaya X330WAN - Manual (Page 180)

Chapter 6 X330WAN CLI Commands
158 Avaya X330WAN User’s Guide
VoIP mode disabled.
5 minute input rate 358 bits/sec, 0 packets/sec
5 minute output rate 17792 bits/sec, 40 packets/sec
0 input drops, 0 output drops, 0 unknown protocols
4 packets input, 256 bytes
0 broadcasts received, 0 giants
0 input errors, 0 CRC, 0 abort
8 packets output, 384 bytes
0 output errors, 0 collisions
Serial 2:2 is up, line protocol is up
Internet address is 60.0.0.2, mask is 255.0.0.0
(advertised IPCP)
MTU 1500 bytes, Bandwidth 640 Kbit
Reliability 255/255 txLoad 1/255 rxLoad 1/255
Encapsulation PPP
Link status trap disabled
Keepalive not set
LCP Opened
IPCP Opened
Last input 00:06:03, Last output 00:00:08
Last clearing of 'show interface' counters 00:06:24
VoIP mode disabled.
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 1 bits/sec, 0 packets/sec
0 input drops, 0 output drops, 0 unknown protocols
3 packets input, 192 bytes
0 broadcasts received, 0 giants
0 input errors, 0 CRC, 0 abort
7 packets output, 320 bytes
0 output errors, 0 collisions
Console asynchronous mode is terminal
Terminal baud rate is 9600
Output Example of X330W-2USP with Frame Relay encapsulation sub-interfaces defined:
X330WAN-2USP-1(super)# show interfaces Serial
Serial 1 is down, line protocol is down
MTU 1500 bytes, Bandwidth 2048 Kbit
Reliability 1/255 txLoad 1/255 rxLoad 1/255
Encapsulation FRAME-RELAY IETF, loopback not set
Link status trap disabled
LMI enq sent 0, LMI stat recvd 0, LMI upd recvd 0, DTE LMI down