Avaya X330WAN - Manual (Page 208)

Chapter 6 X330WAN CLI Commands
186 Avaya X330WAN User’s Guide
ip route
Use the ip route command to establish a static route. The no form of this
command removes a static route.
Syntax
[no] ip route <ip addr> <mask> {{<next-hop> [<next-hop> [<next-hop>]]
| <interface-type> <interface-number>} [<cost>] [<preference>]
[permanent] | Null0}
Parameters
Example
X330WAN-2DS1-1(configure)# ip route 132.55.0.0 255.255.0.0
132.55.4.45 3 high
X330WAN-2DS1-1(configure)# no ip route 134.66.0.0 255.255.0.0
X330WAN-2DS1-1(configure)# ip route 134.66.0.0 255.255.0.0 Null0
• For a X330WAN-2DS1:
X330WAN-2DS1-1(configure)# ip route 135.0.0.0 255.0.0.0 Serial 1:1
permanent
• For a X330WAN-2DS1:
X330WAN-2USP-1(configure)# ip route 192.168.12.0 255.255.0.0 Serial 1
ip routing
Use the ip routing command to enable IP routing. The no form of this command
disables the IP routing process in the device. By default, IP routing is enabled.
Syntax
[no] ip routing
ip addr The IP address of the network.
mask The mask of the static route.
next-hop The next hop address in the network.
interface-type The interface type.
interface-number The interface number.
cost The path cost. The default is 1.
preference Preference, either High or Low. Default is Low.
permanent The route is not disabled if the interface is down.
Null0 Creates a static discard route.