Avaya X330WAN - Manual (Page 46)

Chapter 3 Initial Configuration
24 Avaya X330WAN User’s Guide
For more information, refer to "Priority DLCI" on page 46.
18 Configure an IP address for the Sub-interface using the ip address <ip
address> <mask> [<admin state>] command.
19 Type exit to return to Supervisor mode.
20 Repeat step 3 through step 6 to configure additional Frame Relay Sub-interfaces
on the same Frame Relay interface.
Note: If the Unframed framing option was selected in step 3 for an E1 port, a
Channel Group is automatically created comprising the entire E1 bandwidth. This
Channel Group has the number ‘0’, and for all the subsequent configuration for this
interface use the context
interface serial n:0 where ‘n’ is the port number.
Note: The first IP interface created in the X330WAN automatically becomes the
PMI, described in detail on page 34. It is recommended to configure the Loopback
interface as the first Layer 2 interface and to configure an IP interface on it. After the
PMI is configured, the following message appears:
The primary management interface has changed.
For this change to take effect, you need to copy running-config
startup-config and then reset the device.
Enter the copy running-config startup-config and reset commands at this
stage.
Table 3.1 provides the different configuration contexts for the X330W-2DS1 CLI.
This table uses the following legend:
•
x = physical port number
• y = channel group
• z = sub frame relay interface index
• w = IP interface index
• v = VLAN number
Table 3.1 X330W-2DS1 CLI Interface Contexts
CLI Interface Context PPP Frame Relay
Controller controller e1 (t1) x controller e1 (t1) x
Serial interface serial x:y interface serial x:y
Sub Frame Relay N/A interface serial x:y.z
point-to-point