Avaya X330WAN - Manual (Page 193)

Layer 3 CLI Commands
Avaya X330WAN User’s Guide 171
Syntax
[no] ip bootp-dhcp network <ip net>
Parameters
Example
To select the network 192.168.169.0 as the network from which an address should be
allocated for BOOTP/DHCP requests:
X330WAN-2USP-1(super-if:FabricFastEthernet1:20)# ip bootp-dhcp
network 192.168.169.0
ip bootp-dhcp relay
Use the ip bootp-dhcp relay command to enable relaying of BOOTP and
DHCP requests to the BOOTP/DHCP server. The no form of this command
disables BOOTP/DHCP relay. The default state is
disabled .
Syntax
[no] ip bootp-dhcp relay
Example
To enable relaying of BOOTP and DHCP requests:
X330WAN-2DS1-1(configure)# ip bootp-dhcp relay
To disable relaying of BOOTP and DHCP requests:
X330WAN-2DS1-1(configure)# no ip bootp-dhcp relay
ip bootp-dhcp server (Interface context)
Use the ip bootp-dhcp server command to add a BOOTP/DHCP server to
handle BOOTP/DHCP requests received by this interface. A maximum of two
servers can be added to a single interface. The no form of this command removes
the server.
Note: This command is executed from the Fast Ethernet and FabricFastEthernet
interfaces.
Syntax
[no] ip bootp-dhcp server <ip-address>
ip net The IP subnet.