Rockwell Automation 1715-OF8I Redundant I/O System User Manual - Manual (Page 135)

Rockwell Automation Publication 1715-UM001C-EN-P - March 2014 135
Digital I/O Operation Chapter 3
Follow these steps to reset a fuse.
1. On the Module Properties dialog box, click the Configuration tab.
2. Click Reset for a particular point on the module to reset a fuse.
3. Click OK.
Diagnostic Latch Information
Diagnostic latching lets this module latch a fault in the set position once it has
been triggered, even if the error condition causing the fault to occur disappears.
Latched diagnostic features can be cleared by the Reset Diagnostic Latch service.
IMPORTANT Diagnostic latches are also reset through a software reset or when the I/O
module’s power is cycled.