Rockwell Automation 1715-OF8I Redundant I/O System User Manual - Manual (Page 192)

192 Rockwell Automation Publication 1715-UM001C-EN-P - March 2014
Chapter 5 Configure the Redundant I/O System
Add a 1715-OF8I Analog
Output Module to the Project
In this section, you do the following:
• Add a 1715-OF8I analog output module in Duplex mode to the project.
• Add a 1715-OF8I analog output module in Simplex mode to the project
Step 1: Add a 1715-OF8I Analog Output Module in Duplex Mode
1. Add the new module, referring to page 172 .
The Select New Module dialog box appears.
2. Expand the Analog module list, select the 1715-OF8I module, and click
OK.
The General tab appears.