Rockwell Automation 1715-OF8I Redundant I/O System User Manual - Manual (Page 166)

166 Rockwell Automation Publication 1715-UM001C-EN-P - March 2014
Chapter 5 Configure the Redundant I/O System
8. Click the Module Info B tab.
The Module Info B tab appears.
The Module B Info Tab displays module and status information about the
secondary adapter, in slot 0 or 1. (During initial setup, the secondary adapter is
installed in slot 1. If an IP address swap occurs, the secondary adapter is now in
slot 0.)
This tab also lets you reset a module to its power-up state. The information on
this tab is not displayed if you are one of the following:
• Offline
• Currently creating a module
See Table on page 165 .
9. Click the Internet Protocol tab.
You must be online to configure the Internet Protocol settings.