Rockwell Automation 1715-OF8I Redundant I/O System User Manual - Manual (Page 176)

176 Rockwell Automation Publication 1715-UM001C-EN-P - March 2014
Chapter 5 Configure the Redundant I/O System
The Module Properties dialog box appears.
4. Verify Redundant is Yes for D uplex mode.
Note the additional module slot on the Module Properties dialog box.
5. Click OK.
6. Click the Connection tab.
The Connection tab appears. See page 163.
7. Click the Module Info A tab.
The Module Info A tab appears.
TIP See Online Help in the application for additional
information on how to set Module Definition parameters.