CTL Lx-Lite VoiceSupport - Manual (Page 15)

Installing the Hardware
VoiceSupport LX System Guide 2-1
Chapter 2 Installation and Setup
Chapter 2: Installation and Setup
Installing the Hardware
Tools
Required Phillips screwdriver
Note VoiceSupport systems will have the required software preloaded at the
factory. The software is provided in the event of a system failure requiring
the software to be reloaded.
Mounting the
VoiceSupport
Unit
The VoiceSupport unit is suitable for mounting in a 19 inch rack or can be placed on
a flat surface. There is also a wall mount bracket included with the unit to allow
mounting on a solid flat surface.
Connecting
VoiceSupport
to a LAN The VoiceSupport unit contains a LAN connector on the rear panel. This is an RJ-45
connector providing a Gbit Ethernet connection to a local network. Connect an
Ethernet cable from the LAN port on the rear of the VoiceSupport LX to the network.
Connecting
AC Power The VoiceSupport Power Supply is auto voltage sensing and will accommodate
either 110 or 220 Vac, 60 Hz, single phase power.
1) Connect an AC line cord from the AC receptacle on the rear of the unit to a
grounded 110VAC receptacle. (See Figure 1-3.)
2) Press the Power switch on the rear panel of the unit. Make sure that the green
Power indicator on the front panel is lit. (See Figure 1-2)