Metrohm 781 pH/Ion Meter - Manual (Page 31)

3 Short operating tutorial
780/781 pH/Ion Meter, Manual
21
4 Poor calibration data
• If the calibration data are outside the calibration parameters
defined as the limits (see Section 6.2.2) then a corresponding
message will be shown:
• You can still accept the calibration data with <ENTER>, or re-
ject it with <MODE>.
4 Show calibration data
• You can now display the calibration data with <CAL.DATA>.
If you move the selection bar to the end of the list with <

>,
then in the line
Curve < -> >
you can activate the calibration curve display with <->>.
4 Print calibration report
• With <REPORT> you can now output a calibration report to a
printer or a PC.
• With <CAL.DATA> you can jump directly to the short calibra-
tion report in the report selection list (calib short); this contains
all the data except the calibration curve itself.
• The Select key <->> offers the further option 'calib full';
this also outputs the calibration curve.
ENTER MODE
CAL.DATA
7
REPORT
9