Metrohm 781 pH/Ion Meter - Manual (Page 52)

5.1 Report
42
780/781 pH/Ion Meter, Manual
5.1 Report
REPORT
9
CONFIG
├
report
│ ├
id1
: ├
id2
├
report id
├
instrument id
├
date & time
├
method
├
electrode id
├
signature
└
line feed
In the configuration menu report you can define the output format of
the report header. This describes the first lines of a measuring point re-
port (see also Section 7.2.3) and can be either placed in front of each
measured value to be printed out or before a series of measured values
(see following section).
A report header containing all the elements described here could look
like this:
Report Id: 'mp
Instrument Id: 781 pH/Ion Meter 5.781.0020
Date, Time: Datum 2004-05-24 09:50:56
User *: user C. Weber
Mode / Method / Run number: pH pH-1 run number 9
Electrode Id: electr.id pH electr.1
Sample Id1: id1 batch 21
Sample Id2: id2 sample A01
Signature: Signature ________________________
*The ' user ' line is not configured here. The entry of a user name takes
place automatically when a user has been defined with the <USER>
key. The name remains active until it is deleted or another user name is
selected (see Section 4.3).
id1, id2 (max. 16 characters)
This is where you can define short texts as additional information for the
report header. Each of these entries will be printed out in a single line in
each report. In addition, you can also request these Ids before each
measurement as a preselection (see method parameter preselec-
tions in Section 6), e.g. in order to mark each sample specifically.
report id: ON, OFF
This setting defines whether the report Id is to be printed out in the first
line of the report header. It is used to identify the report.
instrument id: ON, OFF
You can include the instrument identification in the report header if you
want to. It consists of the exact type name of the pH/Ion Meter with the
version number of the instrument software.