Metrohm 781 pH/Ion Meter - Manual (Page 54)

5.2 Printing out measured values
44
780/781 pH/Ion Meter, Manual
5.2 Printing out measured values
MEAS/
PRINT
CONFIG
:
├
print meas.value
: └
print crit
┬
immediate
┬
date & time
│ ├
report header
│ └
calibration report
├
time
┬
date & time
│ ├
report header
│ ├
calibration report
│ ├
time interval
│ └
stop time
├
drift
┬
date & time
│ ├
report header
│ └
calibration report
├
plot
┬
time interval
│ ├
time scale
│ ├
time scale label
│ └
stop time
└
OFF
In the configuration menu print meas.values the output form of
measured values, triggered by <MEAS/PRINT>, is defined. This is only
possible for the direct measuring modes pH, T, U and Conc(direct).
print crit: immediate, time, drift, plot, OFF
Depending upon the print criterion a measured value report with be
transmitted via the RS232 interface to a printer or PC either immediate-
ly, at defined time intervals or only when a drift condition has been ful-
filled. If a stirring sequence is intended before the measurement ( PA-
RAMETERS/measuring parameters/stirrer: control, see Sec-
tion 6), then these print criteria will only be effective when the stirring
sequence has been concluded.
A further way of documenting the measured values is to output a
graphical plot of the measure value signals.
print crit.: immediate
With this setting a measured value report will be produced when
<MEAS/PRINT> is activated from the normal instrument display. The
following options can be used:
date & time: ON, OFF
Here you can choose whether the date and time at which the
measured value was recorded are to be included with each indi-
vidual measured value. This can take place irrespective of wheth-
er a report header is used.
report header: once, always, OFF