3 all key functions at a glance, All key functions at a glance – Metrohm 781 pH/Ion Meter User Manual
Page 43
4 Operation
780/781 pH/Ion Meter, Manual
33
4.3
All key functions at a glance
The functions of all the keys are described below both for the measured
value display and the menu display:
Key
Measured value display
(normal operation)
Menu display
(editing)
ON/OFF
On/Off switch
•
The <ON/OFF> key switches the
instrument on and off
•
This applies even if the lamp of the
LCD display is switched off!
(see Section 5.4)
•
After switch-on the pH/Ion Meter is in
the normal operation display of the last
mode to have been used
On/Off switch
•
The <ON/OFF> key switches the
instrument off at any time.
CONFIG
Opens configuration menu
•
<CONFIG> opens the selection menu
for the instrument configuration.
•
These configuration settings remain
unchanged until they are edited or the
permanent memory of the instrument
configuration is initialized (see Sec-
tion 8.5).
Report selection
•
Direct selection of the configuration
report after <REPORT>.
Changes to configuration
menu
•
The <CONFIG> key can be used to
switch directly from the parameter
menu to the selection menu for instru-
ment configuration.
PARAM
Opens parameter menu
•
The <PARAM> key opens the selec-
tion menu for the method parameters.
•
All parameter settings belong to a
method and are stored method-
specifically with this method.
Report selection
•
Direct selection of the configuration
report after <REPORT>.
Changes to parameter menu
•
With the <PARAM> key you can
switch directly from the configuration
menu to the parameter menu.
CAL
Starts calibration
•
In the pH and Conc (direct) modes the
<CAL> key starts a calibration.
MEAS/
Starts measurement / Prints
out measured value
•
In the pH, T, U and Conc(direct)
modes the <MEAS/PRINT> key trig-
gers a measuring sequence.
•
Depending on the configuration (see