Metrohm 788 IC Filtration Sample Processor - Manual (Page 33)

2.4 Installation for full control with «IC Net»
788 IC Filtration Sample Processor
25
2.4.3 Metrohm IC systems
Metrohm IC systems can be classified into modular IC systems (" MIC")
and compact IC systems (e.g. 761 Compact IC or 790 Personal IC).
The following table gives a review over pre-configured Metrohm IC
systems:
Name Application
MIC 1 Anion or cation system with electronic suppression
MIC 2 Anion system with chemical suppression
MIC 3 Anion and cation system with chemical suppression
MIC 4 Anion or cation system with electronic suppression and preconcentration
MIC 5 Anion system with chemical suppression and preconcentration
MIC 6 Anion system with chemical suppression, preconcentration and matrix elimination
MIC 7 Anion system with chemical suppression and dialysis
The following sections describe the electronic connection of some of
these systems with the 788 IC Filtration Sample Processor on the base
of full control by « IC Net 2.1». Due to similar compilation of MIC 1 / MIC
4 and MIC 2 / MIC 5, only the common used systems MIC 1 und MIC 2
are described. Additionally, the anion and cation system MIC 3 as well
as the dialysis system MIC 7 are included. Please note that with the MIC
7 system the 788 IC Filtration Sample Processor can be used for
dialysis in combination with the 754 Dialysis Unit. For this purpose, the
ultra-filtration cell of the 788 IC Filtration Sample Processor should be
bridged (see section 2.3.10).
For connecting the 788 IC Filtration Sample Processor to 761 Compact
IC and 790 Personal IC, the remote connection is used only.
Therefore, internal methods of the sample processor are used. Please
find the corresponding descriptions in section 2.5 (connection) and
section 4.6.3 (methods).