Metrohm 788 IC Filtration Sample Processor - Manual (Page 53)

3.1 Prerequisites / Preparations
788 IC Filtration Sample Processor
45
3 Operating tutorial
In order to become acquainted with the 788 IC Filtration Sample Proces-
sor and its mode of operation, it is helpful to work through the short
Operating Tutorial. The basic operating steps that are required to prepare
the first sample series and run it with a given method are described here.
For further explanations of the operation, please refer to section 4, which
describes the functions of the individual keys and the programming in
detail.
3.1 Prerequisites / Preparations
x It is assumed that the 788 IC Filtration Sample Processor is fully
installed (see section 2). Don’t forget to mount the splash protection
and the plug cover.
x Connect a 732 IC Detector at the remote connection 30 30 30 30 (see section
2.4).
x Prepare the ultra-filtration cell (see section 2.3.8).
x Choose a simple IC method that you have saved in the 732 IC De-
tector or create a new simple method.
x The <Ï> and <Ð> keys can be used to move the lift up or down.
RESET
CLEAR *
>
ENDSEQ x Install the 6.2041.430 sample rack. Press <RESET> or
<ENDSEQ> + <ENTER>. The 788 IC Filtration Sample Processor
is initialized in this way with the lift and rack placed in the rest posi-
tion. In this position the magnetic rack code can be read so that the
internally stored rack data (position table, etc.) can be loaded.
This should be done after every rack change.
x Insert some sample tubes into the sample rack, beginning with
position 1. Using the keys <Í> and <Î> the rack can be turned
for this purpose.