Cyclades User's Guide - Manual (Page 100)

Performing Basic Network Configuration
84 AlterPath KVM/net Installation, Administration, and User’s Guide
T To Power On the KVM/net
1. Make sure the KVM/net’s power switch is off.
The power is off when the side of the power switch with the circle is
pressed down.
2. Plug in the power cable.
3. Turn the KVM/net’s power switch on.
The KVM/net beeps once.
T To Power On Connected Devices
Do this after “Connecting Servers to the KVM Ports” on page 78.
• Turn on the power switches of the connected computers and devices.
Performing Basic Network Configuration
The administrator must specify basic network settings before regular users
can connect to and manage the KVM/net and the connected devices through a
browser. Do one of the following to assign a fixed IP address to the KVM/net,
and to specify the netmask and other networking parameters:
• Through a console connection, log in and use the wiz command.
See “Configuring Basic Networking Using the wiz Command” on page 85.
• Through a local KVM connection, log in to the OSD and configure
networking through the network screen.
See “Configuring Basic Networking Using the OSD” on page 89.
Before you start, collect the following network information from the
administrator of the network where the KVM/net is to reside.
‰ Hostname:
‰ KVM/net’s public IP address:
‰ Domain name: