Cyclades User's Guide - Manual (Page 310)

Management
294 AlterPath KVM/net Installation, Administration, and User’s Guide
10.Click “apply changes.”
11.Go to “To Reset the Microcode After Upgrade” on page 294.
Microcode Reset
Selecting Management>Microcode Reset in Expert mode brings up the form
shown in the following figure.
Figure 4-50:Microcode Reset Form
You can use the form to reset the microcode after an upgrade.
T To Reset the Microcode After Upgrade
Perform this procedure if you have upgraded microcode as described in “To
Upgrade Firmware” on page 290.
1. Go to Management>Microcode Reset in Expert mode.
The Microcode Reset form appears.