Cyclades User's Guide - Manual (Page 254)

Configuration
238 AlterPath KVM/net Installation, Administration, and User’s Guide
Input Interface, Output Interface, and Fragments
If you enter an interface (such as eth0 or eth1) in the “Input Interface”
field, incoming packets are filtered for the specified interface. If you enter an
interface in the “Output Interface” field, outgoing packets are filtered for the
specified interface.
These fields are shown in the following figure.
The following table defines the fields in the previous figure.
LOG Target
If you select “LOG” from the “Target” field, the following fields and menus
appear in the “LOG Options Section” at the bottom of the form.
Field Definition
Input Interface The input interface (ethN) for the packet
Output Interface The output interface (ethN) for the packet
Fragments The types of packets to be filtered:
All packets
2nd, 3rd... fragmented packets
Non-fragmented and 1st fragmented packets