Cyclades User's Guide - Manual (Page 449)

433
e. Enter the IP address to be assigned to the KVM/net unit. KVM/net must
be in the same subnet as the TFTP server.
f. Enter the IP address of TFTP server where you downloaded and stored
the latest firmware.
g. Accept the MAC address value that is assigned to the KVM/net unit’s
Ethernet card.
h. Accept the default “Auto Negotiate” value for the Ethernet
configuration.
i. The system starts sending a TFTP request to the server to load the
specified firmware.
8. Access to the KVM/net is enabled once the boot is completed.
Note: If you are unable to access the unit or the boot is not successful, then the
zImage may be corrupted or damaged. You should download the firmware
again from the Cyclades FTP server and restart the TFTP procedure described
above.
The unit is now operating from the system RAM. The zImage is required
to be saved in the flash memory.
IP address assigned to Ethernet interface
[192.168.51.243]
Server's IP address [192.168.51.222] :
MAC address assigned to Ethernet [00:60:2E:01:61:0C] :
Fast Ethernet ((A)uto Neg, 100 (B)tH, 100 Bt(F), 10
B(t)F, 10 Bt(H)) [A] :
Sending a tftp request.
Trying file : zImage_kvm_200.bin