Cyclades User's Guide User Manual
Page 226
Configuration
210
AlterPath KVM/net Installation, Administration, and User’s Guide
of the KVM/net and connected devices know the passwords assigned to the
accounts:
•
An account for “admin”
•
If Kerberos authentication is specified for the KVM/net, accounts for all
users who need to log in to the KVM/net to administer connected devices.
•
If Kerberos authentication is specified for KVM ports, accounts for users
who need administrative access to connected devices
1. Make sure an entry for the KVM/net and the Kerberos server exist in the
KVM/net’s /etc/hosts file.
a. Go to Configuration>Network>Host Table in Expert mode.
The “Host Table” form appears.
b. Add an entry for KVM/net if none exists and an entry for the Kerberos
server.
i.
Click “Add.”
The “New/Modify Host” dialog appears.
ii. Enter the address in the “IP Address” field.
iii. Enter the name in the “Name” field.
iv. If desired, enter an optional alias in the “Alias” field.
2. Make sure that timezone and time and date settings are synchronized on
the KVM/net and on the Kerberos server.
Kerberos authentication depends on time synchronization. Time and date
synchronization can be achieved by setting both to use the same NTP
server.
a. To specify an NTP server, follow the procedure under “To Set The
Time and Date With NTP” on page 270.
b. To customize a timezone on KVM/net, follow “Creating a Custom
Timezone Selection” on page 272.
c. Work with the authentication server’s administrator to synchronize the
time and date between the KVM/net and the server.
3. Set the timezone by going to Configuration > System > Time/Date in
Expert mode, as per the following figure. The default is GMT.