Cyclades User's Guide - Manual (Page 28)

Activity LEDs on the Back of the KVM/net
12 AlterPath KVM/net Installation, Administration, and User’s Guide
The LED numbers in the tables below correspond to the numbers in the
previous figure.
Table 1-2: LED Descriptions
Number Label Function Color/Status
1 VID
EN Monitor KVM CAT5
video interface Orange - Lights when an internally-
generated signal is used. This occurs
when the user is not connected to the
port and in the OSD, or when the user is
connected to a port, but a video signal is
not present from the server.
Green - Lights when the server's video
signal is used; this happens when the
server is presenting a valid signal.
2 SYN Monitor KVM CAT5
video interface Green - Lights when the user is
connected to port and a video signal is
detected and "synchronized". This
means that the KVM is presenting the
signal to the station.
Orange - Lights when the video signal
level is detected but not synchronized.
Typically, this takes a very short amount
of time (less than 1/3 second) for the
KVM to synchronize to the server's
video signal upon first connection.
5, 3 LK Monitor RS-232 async
port status • OFF – Indicates the port is not open.
• Orange – Lights when DTR (data
terminal ready) signal is on (when the
port is open).
4, 5 ACT Monitor RS-232 async
activity • OFF – Indicates no data activity.
• Green – Blinks when data is either
being received (RX) or transmitted
(TX).