Cyclades User's Guide - Manual (Page 103)

Installation 87
Performing Basic Network Configuration
6. Enter the domain name.
7. Enter the IP address of the DNS (domain name) server.
8. Enter the IP address for the gateway.
9. Enter the netmask for the subnetwork.
10.To apply and confirm these parameters, see “To Apply and Confirm the
Network Parameters Defined Using the wiz Command” on page 87.
T To Apply and Confirm the Network Parameters Defined
Using the wiz Command
This procedure must be completed immediately after defining network
parameters using the wiz command as described in “To Use the wiz Command
to Configure Network Parameters” on page 86
Domain name[cyclades.com]: domainname
Primary DNS Server[192.168.44.21] :
DNS_server_IP_address
Gateway IP[eth0] : gateway_IP_address
Network Mask[#] : netmask