To connect multiple pms to the kvm/net, To connect multiple pms to the kvm – Cyclades User's Guide User Manual
Page 134
Connecting AlterPath PMs to the KVM/net
118
AlterPath KVM/net Installation, Administration, and User’s Guide
T
To Connect Multiple PMs to the KVM/net
This procedure assumes that you have one AlterPath PM connected to the
AUX port of the KVM/net. See “To Connect an AlterPath PM to the AUX
Port” on page 117 for the procedure.
1. Connect one end of an RJ-45 cable to the Out port of the “master”
AlterPath PM, which is connected to the AUX port of the KVM/net.
2. Connect the other end of the RJ-45 cable to the In port of the next
AlterPath PM (slave).
3. To connect another PM to the slave, connect one end of an RJ-45 cable to
the Out port of an already connected PM.
4. Repeat Step 3 until you have connected the desired number of PMs.
You can control up to 128 power outlets in any combination of PM models.
See “IPDU Power Management” on page 161 for information on managing
your PMs with the Web Manager.