To add a syslog server [wizard – Cyclades User's Guide User Manual
Page 174
Wizard Mode
158
AlterPath KVM/net Installation, Administration, and User’s Guide
The following table has links to the procedures for adding and deleting a
syslog server.
Use this form to configure system logging for the KVM/net. More advanced
configuration of syslog servers and event notification can be done in Expert
mode. To configure system logging for messages relating to KVM ports, in
Expert mode go to “To Configure Syslogging for KVM Ports and
Specify Message Filtering [Expert]” on page 232.
T
To Add a Syslog Server [Wizard]
This procedure assumes you have the following information:
•
The IP address of the syslog server
•
The facility number for messages coming from the KVM/net
1. In Wizard mode, go to “Step 4: System Log.”
The System Log form appears.
2. From the Facility Number drop-down list, select the facility number.
3. In the New Syslog Server field, enter the IP address of a syslog server, and
select the Add button. (Repeat this step until all syslog servers are listed.)
4. The new server(s) appear in the Syslog Servers list.
5. Click “apply changes.”
To Add a Syslog Server [Wizard]