Cyclades User's Guide - Manual (Page 196)

Configuration
180 AlterPath KVM/net Installation, Administration, and User’s Guide
Note: The User 1 and User 2 forms are identical except that User 1 modifies the
User 1 port options, while User 2 modifies the User 2 port options.
4. To change the idle timeout, enter a different number of minutes in the “Idle
Timeout” field.
5. To change the screen saver timeout, enter a different number of minutes in
the “Screen Saver Timeout” field.
6. To change the keyboard type, select a different keyboard from the
“Keyboard type” drop-down list.
7. To change the cycle time, enter a different number of seconds in the “Cycle
Time” field.
8. To change any of the command key portions of KVM hot key
combinations, enter a different letter in the “Quit,” “Power Management,”
“Mouse/Keyboard Reset,” “Video Control,” “Switch Next,” “Switch
Previous,” or “Port Info” fields.
9. Click “apply changes.”
T To Configure IP User (KVM Over IP) Sessions [Expert]
Perform this procedure if you want to redefine the parameters that apply to
KVM port sessions when a remote user is connected through the Web
Manager (in a KVM over IP session).
1. Go to Configuration>KVM>General>IP Users in Expert mode.