To configure group authorization on a ldap server, To configure an smb(ntlm) authentication server, To configure group authorization on a ntlm server – Cyclades User's Guide User Manual
Page 230
Configuration
214
AlterPath KVM/net Installation, Administration, and User’s Guide
T
To Configure Group Authorization on a LDAP Server
On the LDAP server edit the “info” attribute for the group and add the
following syntax.
T
To Configure an SMB(NTLM) Authentication Server
Perform the following to identify the authentication server if any of the ports
is configured to use the NTLM (Windows NT/2000/2003 Domain)
authentication method or NTLM/Downlocal.
1. Go to Configuration>Authentication>SMB(NTLM) in Expert mode.
The SMB(NTLM) form displays as shown in the following figure.
Figure 4-26:SMB(NTLM) Server Configuration Form
2. Fill in the form according to your configuration of the SMB server.
3. Click “Done.”
4. Click “apply changes.”
T
To Configure Group Authorization on a NTLM Server
To configure group authorization install the required tools from the Windows
Server Administration Pack. The primary tools are Active Directory Schema
info: group_name=<Group1>[,<Group2>,...,<GroupN>];