ATEIS IDA8C - Manual (Page 136)

Ateis Studio 136
© 2012 ATEÏS
4.2.2.5 Operation Notice
Once the calibration is successful, don't adjust the level in the rear of DNM component (ex: Monitor Out
C's level or amplifier gain, etc.), but the level can be adjusted which is front of the DNM component (ex:
Input A level or PC output volume, etc.).
4.2.2.6 Two DNM on the Same PDC
If the system needs to use more than one DNM, and to connect a DNM series on same RS485 port,
then the user should plug in the DNM one by one connecting a DNM series to RS485 port. The steps of
plug-in is same as above. Note: The DNM should be connected to a different ID and Series number.
1. For each DNM, plug into the RS485 port of IDA8C/S, and assign an ID for it.