ATEIS IDA8C - Manual (Page 35)

Product Features 35
© 2012 ATEÏS
Optional card to build a global dedicated IDA8C network.
Configurable Audio I/Os
Two configurable 0dB audio I/O port A and B. Each port is available to assemble an audio card.
There are 4 channels on each audio I/O card.
Telephone Line Input
A connector for telephone signal coming from telephone company.(optional).
Telephone Connector
A connector for external telephone connection.(optional).
Bypass Mode Outputs
This port to share the bypass mode microphone signals through the IDA8C-IDA8S network(only
needed when using fiber optic network).
Contact Outputs
8 logic outputs channels to close/open circuit for an external device, this contact is normally open.
Evacuation Inputs
9 evacuation contact inputs that allow the monitoring of external contact. They also can be used in
UGA mode, trigger by a voltage polarization change.
24V DC Output
This connector supplies a 24VDC source.
24V DC Input
Main 24VDC power supply connector.
AC Power Socket
Main 110~240 V 1.2A, 47~63Hz AC power input with fuse. If 24V DC and AC power input at the
same time, IDA8C will use AC power, and switch to DC power if there is no AC power input.
Fuse Rating: 3.15A
Zone Boards
Zone Board1
The following I/Os are belong to zone board1 in IDA8C: speaker zone output ch1~ch4, backup
amplifier1, amplifier zone output ch1 ~ ch4.
Zone Board2
The following I/Os are belong to zone board2 in IDA8C: speaker zone output ch5~ch8, backup
amplifier2, amplifier zone output ch5 ~ ch8.