ATEIS IDA8C - Manual (Page 52)

Ateis Studio 52
© 2012 ATEÏS
Bandwidth = 20Hz ~ 20kHz.
EIN(Equivalent Input Noise)
Sensitivity Minimum Maximum Unit Frequency
0dBu - -81 dBu 20~20kHz@150Ù
-12dBu - -93 dBu 20~20kHz@150Ù
-24dBu - -104 dBu 20~20kHz@150Ù
-40dBu - -112 dBu 20~20kHz@150Ù
-54dBu - -115 dBu 20~20kHz@150Ù
Speaker line/Amplifier
Maximum Power = 100W(RMS).
Maximum Power(Siren + Message) = 1500W.
Configurable Audio Output
Maximum level = 14 dBu
Output Impedance = 50 Ohm
THD+N(Total Harmonic Distortion plus Noise)
Sensitivity Minimum Maximum Unit Frequency
0dBu - 0.04 % 20~20kHz@+4dBu
-12dBu - 0.06 % 20~20kHz@-2dBu
-24dBu - 0.06 % 20~20kHz@-14dBu
-40dBu - 0.06 % 20~20kHz@-30dBu
-54dBu - 0.06 % 20~20kHz@-44dBu
Bandwidth = 20Hz ~ 20kHz.
EIN(Equivalent Input Noise)
Sensitivity Minimum Maximum Unit Frequency
0dBu - -81 dBu 20~20kHz@150Ù
-12dBu - -93 dBu 20~20kHz@150Ù
-24dBu - -104 dBu 20~20kHz@150Ù
-40dBu - -112 dBu 20~20kHz@150Ù
-54dBu - -115 dBu 20~20kHz@150Ù
Configurable Audio Input
Sensitivity
For each channel of configurable audio input card, there are five levels to gain the audio signal.
They are sensitivity values of 0dBu, -12dbBu, -24dBu, -40dBu and -54dBu respectively. The
meaning of sensitivity value is how large the gain for an audio source, and to amplify the giving
minus input source to 0dBu, the figure below is an example when the sensitivity value is set to -
54dBu, and input source is -54dBu, after the gaining circuit of audio card, you'll get the 0dBu of
output.