ATEIS IDA8C - Manual (Page 34)

Ateis Studio 34
© 2012 ATEÏS
connector of 100V audio coming from amplifier
IDA8 output exactly the same audio signal to line A and B. Two speakers can connect to one zone
for redundancy purpose, one connect to line A, another connect to line B. Both speaker lines are
monitored, that's mean if a damage of speaker is detected, a global fault "Line A/B Error" will be
generated.
Backup Amplifier I/Os
Two backup amplifier connectors included 0 dB to amplifiers and 100V return from amplifiers.
Amplifier Zone Outputs
8 Zone 0dB output to amplifiers.
Bypass Mode Input
Contact input to engage the bypass mode paging(CMD).
Contact output to display the state of bypass mode paging(ACK).
EVAC, Fault State Outputs
EVAC Output Contact: this contact is closed if system is under EVAC paging.
Fault Output Contact: this contact is open if a fault is detected.
PDC(Peripherals Device Controller) Connectors
Four RJ-45 connectors to connect consoles or peripheral devices. For examples, PSS AS, URC
AS, PPM AS, ... are connect to IDA8C via this connector.
Ethernet Connector
RJ-45 connector to link IDA8C on an ethernet network. The following end points are communicated
with IDA8C through ethernet networking.
Ateis Studio software
3rd party devices
Voxnet Server
PMIP-D
VNB
PPM-IT5
TERRA Devics
Modbus Protocol
Local Ateis Net Connectors
Optional card to build a local dedicated IDA8C-IDA8S network.
Global Ateis Net Connectors