H3C Technologies H3C S3100 Series Switches - Manual (Page 218)

i
Table of Contents
1 MSTP Configuration ··································································································································1-1
Overview ·················································································································································1-1
Spanning Tree Protocol Overview···································································································1-1
Rapid Spanning Tree Protocol Overview ······················································································1-10
Multiple Spanning Tree Protocol Overview ···················································································1-10
MSTP Implementation on Switches ······························································································1-14
Protocols and Standards ···············································································································1-15
MSTP Configuration Task List ··············································································································1-15
Configuring Root Bridge························································································································1-17
Configuring an MST Region ··········································································································1-17
Specifying the Current Switch as a Root Bridge/Secondary Root Bridge·····································1-18
Configuring the Bridge Priority of the Current Switch····································································1-20
Configuring How a Port Recognizes and Sends MSTP Packets ··················································1-20
Configuring the MSTP Operation Mode ························································································1-21
Configuring the Maximum Hop Count of an MST Region ·····························································1-22
Configuring the Network Diameter of the Switched Network ························································1-23
Configuring the MSTP Time-related Parameters ··········································································1-23
Configuring the Timeout Time Factor····························································································1-25
Configuring the Maximum Transmitting Rate on the Current Port ················································1-25
Configuring the Current Port as an Edge Port ··············································································1-26
Setting the Link Type of a Port to P2P ··························································································1-27
Enabling MSTP······························································································································1-29
Configuring Leaf Nodes ························································································································1-30
Configuring the MST Region ·········································································································1-30
Configuring How a Port Recognizes and Sends MSTP Packets ··················································1-30
Configuring the Timeout Time Factor····························································································1-30
Configuring the Maximum Transmitting Rate on the Current Port ················································1-30
Configuring a Port as an Edge Port·······························································································1-30
Configuring the Path Cost for a Port ·····························································································1-30
Configuring Port Priority ················································································································1-32
Setting the Link Type of a Port to P2P ··························································································1-33
Enabling MSTP······························································································································1-33
Performing mCheck Operation ·············································································································1-34
Configuration Prerequisites ···········································································································1-34
Configuration Procedure················································································································1-34
Configuration Example ··················································································································1-34
Configuring Guard Functions ················································································································1-35
Configuring BPDU Guard ··············································································································1-35
Configuring Root Guard·················································································································1-36
Configuring Loop Guard ················································································································1-37
Configuring TC-BPDU Attack Guard ·····························································································1-38
Configuring BPDU Dropping ·········································································································1-39
Configuring Digest Snooping ················································································································1-40